Even if you’re new to door replacement and feeling a bit intimidated, rest assured that this front door replacement project is totally doable and well within your abilities. The best part is you won’t need any fancy or specialized equipment. That’s what makes this a perfect DIY project for a weekend.
When mounting your new front entry, it’s important to remember that careful planning and thorough preparation are key to achieving success. Sometimes, this project may seem daunting, mainly due to its unfamiliarity. Below is a simple guide o how to go about the front door replacement process.
- Remove The Old Entry
To begin, use a pry bar and hammer to eliminate the current frame. Then, use a similar method to detach the sleek on the door’s exterior.
After removing the frame and trim, proceed to remove any nails and screws that secure the entire door to the house’s frame. You will need an interchanging saw to take away the nails.
After all, attachments are freed, the next step is to remove the entry and frame. Tilt the entire unit carefully and in a controlled manner towards the exterior of the house.
2. Cleaning The Rough Space
The area in your home where the door and frame were once installed now appears as a vacant space. After removing the old door and frame, the next step is to prepare the space.
This involves carefully vacuuming the area to remove any remaining dust, debris, old nails, or screws. This preparation ensures a clean and solid foundation for the upcoming installation process.
3. Protect The open space
When it comes to protecting the boards surrounding the left space of a door during the process of front door replacement, there are a couple of options you can consider.
One option is to incorporate a door sill, which acts as a safeguard. Another effective choice is to use flashing adhesive tape. Whichever option you choose, it’s important to follow the provided instructions to ensure that your home’s planks are protected from water and other potential weather-related hazards.
If you decide to install a projection plate, it’s crucial to make sure it is flat and doesn’t obstruct the proper opening and closing of the door. Once the sill is in place, the next step is to apply flashing friction tape along the entire frame to strengthen it against moisture infiltration.
It’s important to remember that the seams of the flashing tape should overlap to ensure full waterproofing.
4. Installing The Door
When you start installing your new front door, the first thing you need to do is apply a bead of caulk or sealant around the three exposed sides of the brick mold.
At the same time, extending a bead along the sill plate is important. This proactive step is essential as it sets a solid foundation for the rest of the installation process. Doing this ensures that the installation is efficient and effective in achieving the desired outcome.